Maintenance And Care; Information On Environmental Protection; Contact Information - LAS 10112 Manuel De L'opérateur

Feu de position, rectangulaire avec support
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Figure 3: Lifting o the cover glass
Insert the connection cables through the cable bushing from the outside (position 3
in the overview). Add a at plug/crimp connector (not included) to the cables.
Insert the at plugs onto the connection lugs of the contact plates (position 4 in the
overview), Figure 4.
Put the cover glass back onto the housing and press it rmly into place.
Carry out a function check.
Figure 4: Connecting the cable

6. MAINTENANCE AND CARE

6.1 MAINTENANCE
The position light does not need to be maintained with proper use of the product.
Replacing the lamp:
The lamp/festoon bulb may only be replaced by a lamp of identical quality and
design.
Festoon bulb, 12 V, 5 W, SV8,5-8, D10, L36 mm
6.2 CARE
Clean the position lamp only with water or standard vehicle cleaners. Do not use
any aggressive cleaning agents or solvent-based cleaners. Never allow liquids to get
inside the position light.

7. INFORMATION ON ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with the household waste!
Electrical and electronic scrap must be collected separately
and disposed of in an environmentally responsible manner for
recycling. Please contact your community or city administration
regarding disposal options for electrical and electronic scrap.

8. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5

Publicité

Table des Matières
loading

Table des Matières