Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Secure the safety chain using the M6 x 16 screw and washer with nut to the end of the ramp base.
For use as a installation ramp, also attach the wheel stopper using 2 M8 x 15 screws and washers with
nuts to the last cross-bar of the upper section before the joint. The steep side of the wheel stopper
must point in the direction of the joint, see Figure 5.
USE AS LOADING RAMP
PREPARATION:
Unfold the loading ramp fully, see Figure 6. Place the loading ramp with the ramp base on the bed.
If you wish to load a double-track vehicle, place the ramps to correspond with the track width of the
vehicle you wish to load, with the ramp base on the bed. Align the ramps so that they are parallel.
Secure the loading ramps with the safety chain to prevent slippage.
LOADING:
Drive the vehicle to be loaded straight up to the loading ramp. Check to ensure that the wheels form a
line with the ramp. If this is the case, drive slowly and evenly over the ramp onto the bed.
When driving onto the ramp, avoid sudden braking or starts.
USE AS INSTALLATION RAMP
PREPARATION:
Fold the loading ramp together. Mount the wheel stopper as described above.
Place the ramp straight, with the ramp base in front of the wheels of the vehicle. Check to make sure that the front aprons, spoilers and other parts of the vehicle
cannot come into contact with the ramp. Push the ramps up against the wheels.
DRIVING OVER THE RAMPS
Find a second person to assist you with directions. Drive carefully onto the ramp and up
to the wheel stoppers. Drive slowly, otherwise there is a risk of driving over the wheel
stoppers which will result in damage to the vehicle. If you notice that driving has caused
a ramp to slip, immediately stop and check to see whether you can reverse without risks.
If so, reverse and realign the ramps. When the vehicle is on the ramps, secure it to prevent
it from rolling away (activate the parking brake, put into gear, set automatics to „P", put
wedges under the wheels).
6. MAINTENANCE AND CARE
MAINTENANCE:
Before each use, check the screw connections to ensure they are tight. Check the loading ramp for cracks and deformation.
CARE:
Lubricate the joints regularly with oil, e.g. bicycle oil. Immediately repair paint damage to prevent corrosion.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
Please dispose of this device via the recycling bin or the public/municipal collection points.
The materials can be recycled. You make an important contribution to protecting our environment by recycling, material utilisation or other forms of reusing waste
equipment!
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
6
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
Figure 5
Figure 6
Publicité
Table des Matières
