Maintenance And Care; Notes Regarding Environmental Protection; Contact Information - LAS 10102 Manuel De L'opérateur

Lay the cable in the interior of the tail light such that it cannot be bent or crushed, and that it does not come into contact with the
bulbs.
Now attach the tail light to the trailer. To do so, insert the supplied screws into the mounting
holes (item 7 in the overview) from the inside out on the housing, see Figure 2, then through
the holes that were drilled. Put the nuts on, then tighten them.
Insert the bulbs (not included in the scope of delivery) into the sockets. Insert a ball-shaped bulb 12 V, 21 W, BA15S into the socket for the indicator (item 9 in the
overview), and insert a two-filament ball-shaped bulb 12 V, 21/5 W, BAY15D into the socket for the rear/brake light socket (item 13 in the overview).
Carry out a functional test.
If you use the tail light without license plate illumination, then replace the license plate illumination diffusing disc (item 4 in the overview) with the license plate
illumination cover (item 6 in the overview). To do so, carefully press against the diffusing disc from the inside and release the retaining tabs. Remove the diffusing disc
from the outside. Now put the cover for the license plate illumination in position. Ensure that the cover is correctly in place.
Afterwards, place the diffusing disc for the indicator and the rear/brake light back on the housing and screw it into position.

7. MAINTENANCE AND CARE

Clean the tail light with a soft cloth or sponge and water only. Do not use aggressive cleaning agents or solvents.
Carry out a functional check of the illumination system before every journey with the trailer.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be collected separately and disposed of in an
environmentally responsible manner for recycling. Please contact your community or city administration regarding disposal options for electrical and
electronic scrap.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
Figure 2: Fixing screws
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
7