Dru SAXO SL 70 Instructions D'installation Et Mode D'emploi page 25

Now position the chimney breast as required, allowing
enough space around the heater for the heat to escape.
To ensure a good heat supply and discharge, the chimney
breast must be adequately vented. Once it is in position,
fix the appliance to the wall with the wall brackets (3)
and two expanding shells provided, (see fig. 1). Connect
the appliance. The appliance is supplied with the ignition
cable coiled. Decoil the cable after installation to prevent
leakage of the voltage, thus preventing poor ignition.
NB: To ensure the ignition works properly, the ignition
wire must come into as little contact as possible with
the metal parts of the heater and should therefore
not be wound round the gas or pilot-light pipes or the
thermocouple.
2
INSTRUCTIONS FOR INSTALLATION
Build a chimney breast as shown in fig. 2a, depending on
whether you have a window on the left or right.
The requires the use of a service flap. The service flap is
supplied as a standard accessory.
LUX vent component
To ensure a good heat supply and discharge, the chimney
breast must be adequately vented. A vent component, the
LUX vent component, is available from your installer. The
vent component serves to ventilate the chimney breast.
38-c1071sl
fig. 1
21
3
2
1
Saxo SL