Vetus BOW3512EI Manuel D'utilisation Et Instructions D'installation page 16

The electric motor can be installed in various positions.
If the motor is installed horizontally, a support is absolutely neces-
sary.
The motor must then be fitted with the relay upwards.
• Grease the input shaft with an installation compound, like
'Molykote® G-n plus' .
• Grease the threads of the fastenings bolts with 'outboard gear
grease' and install the electric motor to the intermediate flange.
• For a first check, turn the propeller by hand, it should turn easily,
whilst being connected to the output spindle of the electric mo-
tor.
For a horizontal fitting, the filler block (A) must be located un-
der the motor.
16
020586.01
n
ote
vetus® Operation manual and installation instructions bow thruster BOW3512EI 'Ignition Protected'
180º
A
A
6
M8
12 - 15 Nm
(9 - 11 ft.lbf )
Outboard Gear
Grease
Molykote® G-n plus