Product Description And Specifications; Intended Use - Bosch IXO Notice Originale

28 | English
Do not expose the charger to rain or wet conditions. Water enter-
ing a power tool will increase the risk of electric shock.
Charge the power tool only with the supplied charger.
u
Keep the charger clean. Dirt poses a risk of electric shock.
u
Always check the charger, cable and plug before use. Stop using the
u
charger if you discover any damage. Do not open the charger your-
self, and have it repaired only by a qualified specialist using only ori-
ginal replacement parts. Damaged chargers, cables and plugs increase
the risk of electric shock.
Do not operate the charger on an easily ignited surface (e.g. paper,
u
textiles, etc.) or in a flammable environment. There is a risk of fire due
to the charger heating up during operation.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric plug with in-
ternal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be cut off and an
appropriate plug fitted in its place by an authorised customer service agent.
The replacement plug should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible shock hazard and
should never be inserted into a mains socket elsewhere.

Product Description and Specifications

Please observe the illustrations at the beginning of this operating manual.

Intended Use

The power tool is intended for screwing in and loosening screws.
1 609 92A 4SG | (25.02.2019)
Read all the safety and general
instructions. Failure to observe the
safety and general instructions may
result in electric shock, fire and/or
serious injury.
Bosch Power Tools