Practical Advice; Maintenance And Service; Maintenance And Cleaning - Bosch IXO Notice Originale

34 | English
Switching on/off
To start the power tool, press and hold the on/off switch (7).
The worklight (10) lights up when the on/off switch (7) is lightly or fully
pressed, allowing the work area to be illuminated in poor lighting conditions.
To switch off the power tool, release the on/off switch (7).
Fully automatic spindle lock (Auto-Lock)
The drill spindle is locked when the on/off switch (7) is not pressed.
This allows screws to be driven in even when the battery is discharged and
enables the power tool to be used as a screwdriver.
If the drill spindle is blocked, do not press the on/off switch (7) for
u
longer than 15 seconds. Otherwise, the power tool may become dam-
aged.

Practical advice

Only apply the power tool to the screw when the tool is switched off.
u
Rotating application tools can slip off.

Maintenance and Service

Maintenance and Cleaning

Before any work on the tool (e.g. maintenance, tool change etc.) as
u
well as during transport and storage, set the rotational direction
switch to the middle position. There is risk of injury from unintentionally
pressing the on/off switch.
To ensure safe and efficient operation, always keep the power tool
u
and the ventilation slots clean.
If the battery is no longer working, please contact an authorised after-sales
service agent for Bosch power tools.
In order to avoid safety hazards, if the power supply cord needs to be re-
placed, this must be done by Bosch or by an after-sales service centre that
is authorised to repair Bosch power tools.
If the power tool should fail despite the care taken in manufacturing and
testing procedures, the repair should be carried out by an after-sales service
centre for Bosch power tools.
1 609 92A 4SG | (25.02.2019) Bosch Power Tools