Bosch IXO Notice Originale page 32

32 | English
Pay attention to the mains voltage. The voltage of the power source
u
must match the voltage specified on the rating plate of the charger. Char-
gers marked 230 V can also be operated at 220 V.
Note: The battery is supplied partially charged. To ensure full battery capa-
city, fully charge the battery in the charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging process does not damage the battery.
The li-ion battery is protected against deep discharge. When the battery is
discharged, the power tool is switched off by means of a protective circuit:
The application tool stops moving and you can hear a soft whistling sound.
Do not continue to press the On/Off switch after the power tool has
u
automatically switched off. The battery can be damaged.
If the battery charge indicator (4) lights up red when you press the on/off
switch (7) half way in, the remaining battery capacity is less than 30% and
the battery should be charged.
To charge the battery, plug the charging cable (13) into the port (12) on the
bottom of the handle and into the charger (14). Then plug the mains cable of
the charger (14) into the mains socket.
The charging process is interrupted when the on/off switch (7) is fully
pressed.
The battery charge indicator (4) indicates the charging progress. The indic-
ator lights up in green during the charging process. When the battery is fully
charged, the battery charge indicator (4) goes out.
During the charging process, the handle of the power tool will become
warm. This is normal.
If you are not planning to use the power tool again soon, disconnect the
charger from the mains.
The power tool cannot be used during the charging process. It is not defect-
ive if it does not work during the charging process.
Protect the charger from moisture.
u
Follow the instructions on correct disposal.
Changing the tool (see figure B)
Do not use two-sided screwdriver blades that are longer than 25 mm.
u
Insert the screwdriver bit (1) directly into the tool holder (2).
1 609 92A 4SG | (25.02.2019) Bosch Power Tools