Starting Operation - Bosch IXO Notice Originale

Switching on the worklight (see figure C)
By turning the rubber cap (3), you can set the worklight (10) to focused or
diffused light as required. ➊ Remove the rubber cap by pulling it towards
you and ➋ place it back on the tool holder (2) with the appropriate lens.
Off-set Angle Adapter/Angle Screw Adapter/Torque Setting
Adapter (see figures C–F)
You can drive in screws close to edges using the off-set angle adapter (15).
The angle screw adapter (16) enables you to drive screws in hard-to-reach
areas.
The torque presetting ring (18) on the torque setting adapter (17) can be
used to pre-select the required torque in 10 stages. When the correct set-
ting is used, the bit will be stopped as soon as the screw is driven flush into
the material or as soon as the set torque has been reached.
Fitting (see figures C–D)
To fit the adapters, pull off the rubber cap (3) towards you. Then the ad-
apters can be attached. It is possible to fit an adapter offset by 45°.
Removal (see figures E–F)
To remove an adapter, turn the unlocking ring (20) in rotational direction ➊
and pull the adapter off towards you. Then reattach the rubber cap (3).
Operation

Starting Operation

Setting the rotational direction
The rotational direction switch (5) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (7) is
being pressed.
Only operate the rotational direction switch (5) when the power tool
u
is not in use. Otherwise it may become damaged.
Clockwise rotation: To drive in screws, slide the rotational direction switch
(5) forward to the stop.
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational
direction switch (5) backwards.
Bosch Power Tools
English | 33
1 609 92A 4SG | (25.02.2019)