Connecting With A Vcr - Sony VPL-CX80 Mode D'emploi

Connecting with a VCR

This section describes how to connect the
projector to a VCR.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
To connect to a video or S video
output connector
Right side
AUDIO
INPUT A
VIDEO IN
S VIDEO VIDEO AUDIO
OUTPUT
MONITOR AUDIO
2
to audio
output (L)
to S
video
to video
output
output
VCR
1 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
2 Video cable (not supplied) or S-Video cable
(not supplied)
INPUT B
REMOTE RS-232C
1
to audio
output
(R)
To connect to a video GBR/
Component output
Right side
INPUT A
VIDEO IN
S VIDEO VIDEO
OUTPUT
MONITOR
2
to video
GBR/
component
output
VCR
1 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
2 SMF-402 Signal Cable
(not supplied)
HD D-sub 15-pin (male) ↔ 3 × phono jack
Notes
• Set the aspect ratio using "Wide Mode" in
the INPUT SETTING menu according to the
input signal.
• When you connect the projector to a video
GBR or component output connector, select
"Video GBR" or "Component" with the
"Input-A Signal Sel." setting in the SET
SETTING menu.
• Use the composite sync signal when you
input the external sync signal from video
GBR/component equipment.
Connecting the Projector
INPUT B
AUDIO
AUDIO
AUDIO REMOTE RS-232C
1
to to
audio audio
output output
(L) (R)
19
GB