Cleaning The Air Filter - Sony VPL-CX80 Mode D'emploi

4
Loosen the two screws on the lamp
unit with the Phillips screwdriver
(1). Fold out the handle (2), then
pull out the lamp unit by the handle
(3).
5
Insert the new lamp all the way in until
it is securely in place (1). Tighten the
two screws (2). Hold down the
handle to replace (3).
Notes
• Be careful not to touch the glass surface
of the lamp.
38
GB
Maintenance
Handle
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten a
screw.
7
Turn the projector back over.
8
Connect the power cord.
The ON/STANDBY indicator around
the I/1 key lights in red.
9
Press the following keys on the
Remote Commander in the following
order for less than five seconds each:
RESET, <, ,, ENTER.
Note
Do not put your hands into the lamp
replacement spot, or not fall any liquid or
object into it to avoid electrical shock or fire.
Disposal of the used lamp
For the custmers in the USA
This product contains mercury. Disposal of
this product may be regulated if sold in the
United States. For disposal or recycling
information, please contact your local
authorities or Electronics Industries Alliance
(www.eiae.org http://www.eiae.org).

Cleaning the Air Filter

The air filter should be cleaned every 1000
hours.
Remove dust from the outside of the
ventilation holes with a vacuum cleaner.
1000 hours are approximate. This value
varies depending on the environment or
how the projector is used.