Direct Power On/Off Function; Effective Tools For Your Presentation - Sony VPL-CX80 Mode D'emploi

Notes
• When unplugging the AC power cord, ensure
that the lens protector closes and the powered
tilt adjuster is put away in the projector.
Moving the projector with the powered tilt
adjuster rised may damage the adjuster.
• Turn off the projector according to the
procedure in "Turning off the power", then
cool it down when storing the projector in the
carrying case.

Direct Power On/Off Function

If you will be using a circuit breaker to turn
the power for the entire system on and off,
set the direct power on function to "On."
When you turn off the power, you can also
just unplug the power cord without pressing
the I / 1 key. The internal circuitry will
cause the fan to automatically operate for a
certain time even after the power cord is
removed.
Note
However, if the unit has been on for less than
15 minutes, the fan might not begin to turn as a
result of inadequate charging. In that case,
follow the procedure for turning off the power
as described in "Turning Off the Power" on
page 22.
Effective Tools for Your
Presentation
To enlarge the image (Digital Zoom
function)
You can select a point in the image to
enlarge. This function works when a signal
from a computer is input.
This function does not work when a video
signal is input.
1
Project a normal image, and press the
D ZOOM + key on the Remote
Commander.
The digital zoom icon appears in the
center of the image.
26
GB
Other Functions
2
Move the icon to the point on the
image you want to enlarge. Use the
arrow key (M/m/</,) to move the
icon.
3
Press the D ZOOM + key again.
The image where the icon is located is
enlarged. The enlargement ratio is
displayed on the screen for a few
seconds.
By pressing the + key repeatedly, the
image size increases (ratio of
enlargement: max. 4 times.)
Use the arrow key (M/m/</,) to
scroll the enlarged image.
To return the image back to its
original size
Press the D ZOOM – key.
Just pressing the RESET key returns the
image back to its original size immediately.
To freeze the image projected
(Freeze function)
Press the FREEZE key. "Freeze" appears
when the key is pressed. This function works
when a signal from a computer is input.
To restore the original screen, press the
FREEZE key again.
Digital zoom
icon