Connection Examples; Connecting With A Computer, Vcr Or Active Speakers - Sony VPL-X2000U Manuel D'installation

Connection Examples

Also refer to the instruction manual of the equipment to be
connected.
When making connections, be sure to:
• turn off all equipment before making any
connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted may generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
Note on the VPL-X2000E model
The optional IFB-X2000E interface board is required
for using the VIDEO connectors.

Connecting with a Computer, VCR or Active Speakers

SMF-400 Monitor cable
(5BNC˜HD D-sub 15-
pin) (not supplied)
Use the optional ADP-20
signal adapter when
connecting with a
Macintosh computer.
38
(GB)
VCR
to
to S VIDEO OUT VIDEO
OUT
S video cable
(not supplied)
Rear
INPUT C INPUT B INPUT A VIDEO
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX
0
Audio cable
(not supplied)
Audio cable
(not supplied)
Computer
Note
Set INPUT-A in the SIGNAL SELECT menu to RGB.
For details, see page 57 (GB).
Connecting a BNC connector
2 Turn to the right.
1 Align the pins with the pin holes
and push in the plug into the
socket.
to AUDIO OUT
Video cable (not supplied)
Audio cable
(not supplied)
+
–
to AC IN
Active speakers
to a wall outlet
AC power cord
(supplied)
Signal flow
: