Tone Control - Treble And Bass; Clock Time Setting - PERFECTPRO DABBOX Mode D'emploi

Tone control - Treble and Bass

You can set up a custom treble and bass setting to your liking.
1. Make sure your radio is turned on. Press the Volume control knob to
enter the Treble adjustment mode.
2. Rotate the Volume control knob until the desired level (between -5
and +5) is displayed. The sound will change as you adjust the level.
Press the Volume control knob to confirm the setting. You will enter
the Bass adjustment mode.
3. Rotate the Volume control knob until the desired level (between -5
and +5) is displayed. Press the Volume control knob to confirm the
Bass setting.
SAFETY AND COURTESY NOTE:
To prevent possible hearing damage, do not listen at high volume levels
for long periods or put your ears too close to the speaker.
Please use the volume level responsibly with respectable consideration
of the situation and other people or animals in the vicinity.

Clock time setting

Setting the time format
1. Press the Power On/Off button to turn on the radio.
2. Press and hold the Info/Menu button to access the menu for the
current mode. Rotate the Tuning control knob to select "System
Setting" and press the Tuning control knob to enter the system
settings menu.
3. Rotate the Tuning control knob to select "Time" and press the Tuning
control knob to enter the time menu.
4. "Set 12/24 hour" is now shown on the display. Press the Tuning
16
control knob and rotate the Tuning control knob to select the 12 or
24 hour format. The selected format is indicated with an asterisk and
used in standby mode and on the playing mode screen.
Automatically updating the clock
Your radio will normally update the clock automatically using the DAB
or FM signal. If no signal is available, then you need to set the time
manually. After a power failure the radio will then set its clock the next
time that you turn on the radio in DAB or FM mode. Alternatively you
may specify that the time is not automatically updated. In this case the
clock must always be set manually after a power interruption.
1. With your radio switched on, press and hold the Info/Menu button to
access the menu for the current mode.
2. Rotate the Tuning control knob to select "System Setting" and press
the Tuning control knob to enter the system settings menu.
3. Rotate the Tuning control knob to select "Time". Press the Tuning
control knob to enter the time setting menu.
4. Rotate the Tuning control knob to select "Set Time/Date" and press
the Tuning control knob to enter the setting.
5. Rotate the Tuning control knob to select "Auto". Press the Tuning
control knob to enter the auto-update menu.
6. Rotate the Tuning control knob to choose an update option from
"Update from Any" "Update from DAB" or "Update from FM" as
required. Alternatively, you can also select "No update" in order to
disable automatically updating the clock. Press the Tuning control
knob to confirm your choice.
Note:
If you select "Update from Any", "Update from DAB", "Update from
FM" the current time received will be displayed. If no signal is found
you should either position the radio or its aerial so that a signal can be
received, or revert to manual clock mode.