Connecting External Components - JVC KD-X360BTS Manuel D'instructions

INSTALLATION/CONNECTION

Connecting external components

Connecting external amplifiers via output terminals
KD-X360BTS KD-X260BT/
KD-SX25BT
Output terminals
Output terminals 2-way crossover setting
REAR : Rear output
FRONT : Front output
SW : Subwoofer output
REAR/SW : Rear/subwoofer output
KD-X360BTS: MIC (Microphone input terminal) (page 15)
KD-X360BTS:
Expansion port (12 V 500 mA): To the optional SiriusXM Vehicle Tuner
(commercially available) (page 12)
KD-X260BT/KD-SX25BT:
Microphone input jack (page 15)
Signal cord (not supplied)
3-way crossover setting
Tweeter output
Mid Range output
Woofer output
Woofer output
Remote wire (not supplied)
JVC Amplifier*2
*2 Firmly connect the ground wire of the amplifier to the car's chassis to avoid damaging the
unit.
To remote lead
(blue/white) of
the wiring harness.
(Page 40)
41
ENGLISH