Storing The Product; Troubleshooting - Ryobi P4360 Manuel D'utilisation

STORING THE PRODUCT

See Figure 23.
 Clean all foreign material from the product. Store
idle unit indoors in a dry, well-ventilated area
that is inaccessible to children. Keep away from
corrosive agents such as garden chemicals and
de-icing salts.
 Always place the scabbard on the saw bar
when transporting or storing the pole saw. The
scabbard is a snug fit and must be attached
very carefully due to the sharp teeth on the
saw chain. This is best done by grasping the
scabbard at one end, in the center portion of
the scabbard, and carefully sliding it over the
chain as shown. Use caution to avoid the sharp
teeth of the chain.
PROBLEM
Bar and chain
running hot and
smoking.
Motor runs,
but chain is not
rotating.
MAINTENANCE

TROUBLESHOOTING

CAUSE
Check chain tension
for overtightened
condition
Bar lube reservoir
empty
Chain tension too
tight.
Check guide bar and
chain assembly.
Check guide bar and
chain for damage.
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment to ensure
Page 19 — English
NOTE: The saw chain is very sharp. Always
wear protective gloves when handling the
chain.
Tension chain. Refer to Chain Tension earlier in this manual.
Check bar lube reservoir.
Retention chain. Refer to Chain Tension earlier in this
manual.
Refer to Replacing the Bar and Chain earlier in this
manual.
Inspect guide bar and chain for damage.
call us First
call the Ryobi Help Line!
®
your complete satisfaction.
scabbard
REMEDY
Fig. 23