Environmental Protection; Symbols On The Product - Ryobi RTS1800 Traduction Des Instructions Originales

If the power supply cord is damaged it must be repaired
The blade has sharp edges and may also remain hot
Clean the saw and its accessories from dust regularly,
Use a hand brush or vacuum cleaner to remove dust
WARNING
Do not attempt to disassemble the blade guard assembly
The table saw is lubricated at the factory and should not
parallelism, see the "Checking and setting the bevel
angle" and "Checking and setting the parallelism of the
CHECKING AND SETTING THE BEVEL ANGLE
NOTE: Setting the blade to be 90° from the table results in
Turn off the power and remove the plug from the wall
Pay particular attention to the saw blade tips, they are
Raise the blade and riving knife assembly to its highest
Ensure the blade and table surface are clear of dust
Place a 90° "set square" against the table surface and
the blade tips during this measurement as it will result
There should be no gaps between the edge of the set
square and the blade or the table, in this condition
the blade is in a true vertical alignment and no further
If a gap exists, loosen the bevel locking knob and
carefully move the angle of the bevel whilst constantly
Loosen the screw on the bevel angle indicator and
Repeat this operation to check and set various angles
CHECKING AND SETTING THE PARALLELISM OF THE
BLADE TO THE MITRE GUIDE SLOTS
Turn off the power and remove the plug from the wall
Pay particular attention to the saw blade tips, they are
Raise the blade and riving knife assembly to its highest
Complete the checks detailed in this manual "How to
Take the mitre angle guide and fit it into one of the slots
Place a steel ruler firmly against the mitre angle guide
and with the straight end of the ruler set it to touch the
should have the same level of contact with the blade
then the parallelism between blade and table slots
the slot on the other side of the table using the same
ADJUSTING THE PARALLELISM OF BLADE TO TABLE
SLOTS
There are two bolts at the front of the saw blade and two
When these bolts are loosened, the entire blade, riving
knife and motor assembly can be moved to accurately align
return your table saw to the nearest authorised Ryobi

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
and packaging should be sorted for

SYMBOLS ON THE PRODUCT

Safety alert
CE conformity
EurAsian Conformity Mark
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR
English | 7