Ryobi RTS1800 Traduction Des Instructions Originales page 6

Keep the floor in the working area free from excessive
Keep the surface of the table, fence and mitre guide
must slide smoothly and not catch or snag anywhere
Use only blades specified in this manual, complying
Use only saw blades that are marked with a speed
may result in unexpected events which could cause
improperly set blades produce narrow kerf causing
Never use blade washers or bolts that are defective or
Saw blades should be carried in a holder whenever
Do not operate the tool without the table insert and
Unless performing a non through cut, always keep
the blade guard and riving knife in place and in proper
Always use the saw blade guard and riving knife for
operations are those in which the blade cuts completely
Always ensure you thoroughly check the material you
intend to cut, particularly when using recycled wood, for
or similar items contact the blade whilst cutting the saw
No dado cuts are allowed or possible with this power
Never reach into the area near the saw blade when it
Never attempt to stop a machine in motion rapidly by
4 | English
Serious accidents can be caused unintentionally in this
Remove the workpiece and ensure that the saw blade
When transporting the machine, remove the blade
lower the blade so it is below the table surface in its
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorised
Do not use any attachments or accessories not
attachments or accessories not recommended can
Appliances used at many different locations including
open air should be connected via a residual current
If the power to the table saw is interrupted, the
SPECIFIC SAFETY INSTRUCTIONS FOR WOOD
CUTTING BLADE
Please read the manual and instructions carefully
The power tool must be in good condition, the spindle
Ensure the operator is adequately trained in safety
Always wear goggles and ear protection when using
Use only blades specified in this manual, complying
Observe the maximum speed marked on the saw
Always use blades with correct size and shape of arbor
Do not use saw blades with a body thickness greater
or a width of the groove cut (kerf) smaller than the
Do not use blades of larger or smaller diameter than