Assembly; Important - Franke AQCT0031 Notice De Montage Et De Mise En Service

11. Assembly

Warning!
Only operate the fitting with the specified filters.
Failure to observe this instruction can result in damage to the fitting.
Warning!
• Operate the product only with safety extra low voltage (SELV). The components
do not have to be earthed.
• Secure the power supply with an residual current circuit breaker (RCD).
Failure to observe this instruction can result in death or material damage due to
electric shock or fire, for example.
☞

Important!

Prior to the assembly process, flush the pipe work in accordance with DIN 1988.
☞
To protect the tiles, use masking tape when marking and drilling. Drill at low speed.
☞
Depending on the composition of the wall, special dowels may have to be used
(to be provided by the customer).
Fig. A: Water connection from above
Fig. B: Water connection from rear
11.1 Only for water connection from the rear: Install the connection bracket (a) leak-tight.
11.2 Screw in the water volume regulator (b) leak-tight.
11.3 Align the water volume regulator so that the locking screw and operating element
are freely accessible.
11.4 For a shower head height of 2.10 m to 2.30 m, mark drill holes for installation at a
height (c) of 2.14 m to 2.34 m from the upper edge of the finished floor.
11.5 Drill holes in accordance with these markings.
11.6 Insert the dowels.
11.7 Screw on the suspension rail.
11.8 Suspend the shower panel.
11.9 Mark the remaining drill holes.
11.10 Remove the shower panel.
11.11 Drill holes in accordance with these markings.
Insert the dowels.
☞
The battery compartment or power supply and extension cable are not part of the
scope of delivery (see Accessories,
☞
If you are using a wall-mounted power supply unit, it must be installed around 3 m
away from the shower.
info@hygiene-shop.eu - www.hygiene-shop.eu
Chapter 23).
7