Publicité
Les langues disponibles
Les langues disponibles
WARNING:
recommended by D
WAlT for use with this appliance could be
e
hazardous.
WARNING:
accessory or attachment other than specified in this manual on this
trimmer. Serious injury or product damage may result.
Use D
WALT replacement spool Model No. DWO1DT801 or
e
DWO1DT802.
• .080 inches (2.032 mm) diameter round nylon monofilament line is
recommended to maximize runtime and performance. The use of
round, shaped, or thicker line will
reduce runtime.
Replacing the cutting Line (Fig. 2, 9–12)
1. Remove battery.
2. Turn spool (9A) clockwise to unlock as shown in Figure 9. The
white nub (12B) inside the spool will rotate away from the spool
window (9B) to indicate it is unlocked.
FIG. 9
9B
9A
3. Pull the spool straight out to remove.
4. Remove any dirt and grass from the spool and housing.
The use of any accessory not
Do not use any blades, or any
FIG. 10
10A
10C
10B
5. First, wind new line in the channel of the spool closest to the
holding slots (10C) as shown in Figure 10.
6. Place the end of the cutting line
(10A) into the retaining hole (10B).
7. Wind the cutting line onto the
spool in the direction of the arrow
on the bottom of the spool. Make
sure to wind the line on neatly
and in layers. Do not crisscross
(Fig. 11).
8. When the wound cutting line
reaches the beginning of the
holding slots (10C), cut the line
approximately 4 inches (106 mm).
9. Push the line in the holding slots on one side of the spool to hold
the first line while you wind the second line.
10. Repeat the above procedure for the second cutting line on the
lower section of the spool.
CAUTION:
appropriate type of cutting line. ensure that cutting line is present in
both sections of the spool as shown in Figure 11.
11. Once both lines are wrapped around
the spool (9A), place your thumb on
the holding slot to further secure the
string and feed the end of each line
through the two holes (12A) on either
side of the head in the spool housing
(H) as shown in Figure 12.
1 2. Line up the white nubs (12B) inside
the spool housing with the recesses
11
FIG. 11
Before you begin trimming, only use the
FIG. 12
12B
12C
12A
Publicité
