DeWalt DCST960 Guide D'utilisation page 15

3. Use a screwdriver to push the tab of each connector (15A) down
and slide the connectors off of the plates (15B) (Fig. 15).
4. Using a T15 screwdriver, remove the four inner screws (15C) from
the bridge (15D) of the motor housing and pull the bridge out of the
housing.
5. Using a T10 screwdriver, remove the four baffle screws (16A)
from the bottom of the bridge (15D) and pull the baffle (16B) off of
the bridge (Fig. 16).
FIG. 16
16B
16A 16A
16C
6. Pull the brush card (16C) out of the bridge.
7. Slide the new brush card into the bridge ensuring the tab (17A)
on the brush card lines up with the notch (17B) in the bridge as
shown in Figure 17.
8. Replace the baffle (16B). Make sure to install it with the smooth
side facing out.
9. Replace and tighten the four baffle screws (16A).
10. On the new brush card, move the
springs (18A) off of the brushes (18B)
and rest them on the top of the brush
card as shown in Fig. 18. Push the
brushes toward the outside of the
brush card so the center of the card
FIG. 17
17A
17B
FIG. 18
18A
18B
is open. This is needed when installing the brush card and bridge
back into the motor housing.
11. Replace the bridge (15D) so that the plates (15B) are on the
same side as the connectors (15A).
12. Move the springs (17A) back into place so they push the
brushes (17B) into the center.
13. Replace and tighten the four inner screws (15C).
14. Slide the red connector onto the plate marked with the +
sign. Then slide the black connector onto the plate marked with
the – sign.
15. Replace the case (14B).
16. Replace and tighten the four outer screws (14A).
Accessories
WARNING:
offered by D WAlT, have not been tested with this product, use of
e
such accessories with this appliance could be hazardous. To reduce
the risk of injury, only D WAlT recommended accessories should be
e
used with this product.
Recommended accessories for use with your appliance are available
at extra cost from your local service center. If you need any assistance
in locating any accessory, please contact D
701 East Joppa Road, Towson, MD 21286, call 1-800-4-D
(1-800-433-9258) or visit our website: www.dewalt.com.
Repairs
The charger and battery pack are not serviceable. There are no
serviceable parts inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement) should
be performed by a D WALT factory service center, a D
e
authorized service center or other qualified service personnel. Always
use identical replacement parts.
13
Since accessories, other than those
WALT Industrial Tool Co.,
e
WALT
e
WALT
e