17. Troubleshooting
Fault
Possible cause
1. Blade
dissolves
To slightly tightened fastening nut
after switching off
the engine
2. Engine
will
not
a) Failure mains fuse
start
b) Defective extension cable
c) Connections on motor or switch not
in order
d) Motor or switch faulty
3. Motor wrong direc-
a) Capacitor faulty
tion of rotation
b) Wrong connection
4. Motor will not work,
a) Cross section of the extension cable
the fuse is activ
does not suficiently
b) Overload by a blunt saw blade
5. Fire marks on the
a) blunt saw blade
cutting surface
b) wrong saw blade
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Possible cause
Tighten the right hand thread nut
a) Check mains fuse
b) Replace extension cord
c) Repair by electrical specialist
d) Repair by electrical specialist
a) Repair by electrical specialist
b) Exchange polarity of outlet by an qualiied electrician
a) see „Electrical connection"
b) Change saw blade
a) Sharpen or change saw blade
b) Change saw blade
GB | 39