Monoblock Recirculation Filter - Novy Zen 7520 Mode D'emploi

Replacing the grease fi lters
− Before replacing the grease fi lter, clean the edges of the
part in the extractor hood in which the fi lter is placed.
− Grasp the fi lter with 2 hands.
− Make sure that the lock or the lip on the fi lter is on the
bottom side.
− Insert the back of the fi lter in the opening, press the fi lter
upwards at the front and make sure it clicks tight.

You can obtain a new grease fi lter from a dealer
or the Novy website. Article number grease
fi lter: 7400.020
3.3 Monoblock recircuilatiefi lter
The hood is equipped with 1 monoblock fi lters behind
the grease fi lter .
Only use the Novy monoblock fi lter in the cooker hood.
Replacement indicator monobloc recirculation fi lter

Indication: red indicator light stays on
After a set time a red indicator light on the appliance shows
that the monobloc fi lter must be replaced.
Reset the cleaning indicator


After replacing the monblock fi lter(s), carry out
the following action. The motor of the cooker
hood must be running. Simultaneously press
and for 3 seconds until the red indicator led
3
fl ashes 3 times for confi rmation. If the cooker
hood is not reset, it will automatically reset
after the motor of the cooker hood has been
switched on 10 times.
Installing the monoblock fi lter
Open the bottom plate. Remove the grease fi lter.
Compress spring (A) and turn it downwards and place
monoblock fi lter (B) into the cooker hood.
Close lock spring (A) by compressing it again and securing
it in the slot provided. Place grease fi lter (C) in the cooker
hood again.
Close the bottom plate.

You can obtain a new monoblock fi lter from
2
specialist retailers or via the Novy website.
Article number monoblock fi lter: 7300055
3.4 Replacing the lighting
Replacing the led lighting
First, remove the power supply from the hood and allow
the lighting to cool down suffi ciently.
1. Carefully slide the spotlight holder dow; next, open up
the spotlight holder by means of a tilting movement.
– 38 –