Cleaning Indications; Grease Filter Cleaning Indicator; Recirculation Filter Replacement Indicator (1861 Only) - Novy Easy 1851 Mode D'emploi

This action temporarily halts the automatic extraction. The
automatic extraction is reactivated the next time the appliance
is switched on.
Delay function extraction mode (only 1851): This function
starts up after the cooking stops. With it, all the last cooking
vapours are extracted from the kitchen for a pre-set time by
the downdraught extraction tower at low extraction power. The
delay time is set by default to 10 minutes in extraction mode. It is
advisable always to carry out this function completely. After the
end of the delay time, the extractor switches off automatically.
The delay function can be switched off manually by pressing
the button again.
Delay function recirculation mode (only 1861): This function
starts up after the cooking stops. With it, all the last cooking
vapours are extracted from the kitchen for a pre-set time by
the downdraught extraction tower at low extraction power. With
recirculation, the recirculation filters are dried, and the delay
time is set to 30 minutes by default. It is advisable always to
carry out this function completely. After the end of the delay
time, the extractor switches off automatically.
The delay function can be switched off manually by pressing the
button again, but this is advised against to avoid affecting
the service life and operation of the recirculation filter.

6 CLEANING INDICATIONS

6.1 Grease filter cleaning indicator

The grease filter should be cleaned after 20 hours of cooking.
This is automatically indicated by the appliance.
When the appliance is switched on and the extraction power
is set to 0, the time remaining before cleaning the filter can be
read off from the timer display.
After 20 hours of cooking, GrF 00h will appear on the timer
display.
Grease filter remaining time
Press the zone selection button of the
extractor
Press above the zone selection button of
the extractor
The remaining time is indicated.
Resetting the grease filter indicator
Press the zone selection button of the extractor
Press above the zone selection button of
the extractor
Press 00h for 3 seconds until it changes to 20h
Then press 20h again for 3 seconds to confirm

Follow the cleaning instructions set out in the
chapter Cleaning and Maintenance.
6.2 Recirculation filter replacement indicator
(1861 only)
The Monoblock filter should be changed after 450 hours of
cooking. This is automatically indicated by the appliance. After
450 hours of cooking, odF 00h will appear on the timer display.
Grease filter remaining time
Press the zone selection button of the extractor
Press 2x above the zone selection button of
the extractor
The remaining time is indicated.
Resetting the grease filter indicator
Press the zone selection button of the extractor
Press 2x above the zone selection button of
the extractor
Press 00h for 3 seconds until it changes to 450
Then press 450 again for 3 seconds to confirm

Follow the replacement instructions set out in
the chapter Cleaning and Maintenance.
– 52 –
Grease filter
Recirculation filter
Display
GrF
xxh
20h
Display
odF
xxh
450h