Novy Zen 7520 Mode D'emploi page 39

2. Removing the LED lamp:
A. First disconnect the cable to the LED to be replaced.
Disconnect by means of releasing the lock, by applying
light pressure while at the same time pulling away.
B. Next, remove the LED to be replaced by making a gentle
rotating movement to the left.
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the LED
light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker hood and
reconnect the power.
Change in colour temperature with LED-lighting
First make sure that the power supply of the hood has
been disconnected. Remove the plug from the hood or
switch off the power group.
The colour of the LED-lighting has been set to 2.700 K
(warm white) by default. If the colour is to be changed to
4.000 K (neutral white), follow the instruction given below:
− Open the bottom plate at the bottom of the hood.
− Press with two hands against the side of the inox lamp
holder and carefully pull down simultaneously, so you
get access to the lighting on the inside.
− The wiring has been connected to the LED-lamp with
a connector.
− Disconnect the connector from the LED-lamp and move
the wiring to the other free connection on the lamp.
− Repeat this for all four LED-lamps.
− Then close the inox lamp holder again.
The colour of the LED-lighting has now been changed
from 2.700 K to 4.000 K.
Lamps of the ambient lighting
Unscrew the screws on top of the structure. Open the covers.
Turn the lamp a quarter (1). Push it to the front, until it
comes out of the holder. (2). Pull the lamp to the top.(3)
The atmospheric lighting contains four lamps. When chan-
ging the lamps, we advise you to order the new lamps with
Novy in order to avoid difference in colour.
– 39 –