Controls And Functions; Turning Extraction On And Off; Lighting - Novy Zen 7520 Mode D'emploi

2 CONTROLS AND FUNCTIONS

2.1 Operating the device 2.1 Operating the device
1
Switch on / off / ambient lighting
2
Decrease speed level
3
Increase speed level
4

Lighting

5
Indication lights green speed 1,2,3
6
Indication light red Power mode
2.2 Turning the extraction on and off
Turning the extraction on off
Press button 1 to turn on the extractor. The extractor
always starts in the function last used (lighting and/or motor).
Turning the extraction off with delay mode
To set delay mode press key
The fi rst indicator light fl ashes, the other indicator lights
come on at the last position set. After 30 minutes the motor
and lighting automatically switch off.
The delay time is set by default to 30 minutes in extraction
mode. It is advised to always fully allow this function to work.


Use the delay time of 30 minutes so the
cooking odours can be properly removed in
the monobloc fi lter.
Switching extraction off without delay mode
Press key twice.
1
Extractor power level
To increase the power level press key
1 once.
.
3
To decrease the power level press key
− Three green LEDs
6
− The red LED shows the Power position. The Power
position is only used if there are strong odours, or a lot
of smoke or vapour. Its use must be kept to a minimum
because of the large extraction of air in this position.
− The Power position automatically goes back to speed
three after 6 minutes.
− The motor has a thermal switch that switches the motor
off with overheating. After cooling the motor will switch
on again.


Determining the cause of overheating is re-
quired. This can be caused for example by a
pan fi re, the impeller motor being blocked or
an object getting in the exhaust opening and
causing it to be partly or fully blocked.
Auto-Stop
To avoid the extractor hood from staying on, the motor is
automatically switched off after 3 hours (only if in 3 hours
operation has not been changed). The extractor hood
lighting stays on.
2.3 Lighting
Turning the lighting on and off
To turn the lighting on or off press
The light works independent of the motor.
The LED lighting has a soft on/soft off mode, which means
that the lighting will evenly go on and off. When switching
on the lighting, this will always light up with full power and
it can also be used when the fan is off.
Dimming LED lighting
When the LED lighting has been switched on, it can be
dimmed by keeping key
Change in colour temperature with LED-lighting
You can change the colour temperature of the LED-lighting
form 2.700 K (warm white) into 4.000 K (neutral white). The
description for changing this can be found in section 3.4.
Ambient lighting
Press key 1 for 3 seconds and the ambiant lighting will
start. Or press the Novy-button on the remote control.
– 35 –
.
2
5 show positions one to three.
.
4
pressed.
4