Monoblock Recirculation Filter (Optional); Led Lighting - Novy Pure'line Compact 6810 Mode D'emploi

Accessing the grease fi lter
Take hold of the right and left side of the bottom panel
(A) and pull down simultaneously. Remove the fi lter (B) by
tak ing hold of its hook and pulling down.
Cleaning the grease fi lter
The metal grease fi lter can be cleaned by hand or in a dish-
washer. We recommend cleaning the grease fi lter by hand.
Cleaning the fi lter by hand:
− Immerse the fi lter in a solution of boiling water to which
a degreasing detergent has been added.
− Use a brush for cleaning
− Then rinse the fi lters with warm water under a tap and
allow them to dry.
Cleaning the fi lter in a dishwasher:
− Use a customary dishwasher detergent
− Do not put the saturated grease fi lters together with
crockery in the dishwasher
− Select a programme with a low temperature
− After cleaning allow the fi lter to drain.


When cleaning in a dishwasher the fi lter may
discolour as a result of the salt content. This
does not affect its operation.
Replacing the grease fi lters
− Before replacing the grease fi lter, clean the edges of the
part in the extractor hood in which the fi lter is placed.
− Grasp the fi lter with 2 hands.
− Make sure that the lock or the lip on the fi lter is on the
bottom side.
− Insert the back of the fi lter in the opening, press the fi lter
upwards at the front and make sure it clicks tight.

You can obtain a new grease fi lter from a dealer
or the Novy website. Article number grease
fi lter: 6830.020(2x).
3.4 Monoblock recirculation fi lter (optional)
When selecting recirculation, always set the recirculation
programme on the extractor hood (see paragraph 2.4)
If recirculation is chosen the appliance is connected to an
outlet box with a monobloc recirculation fi lter.
Replacement indicator monobloc recirculation fi lter

Indication: red indicator light stays on
After a set time a red indicator light on the appliance shows
that the monobloc fi lter must be replaced.
Reset the replacement indicator

After replacing the monblock fi lter(s), carry out
the following action. The motor of the cooker
hood must be running. Simultaneously press
and for 3 seconds until the red indicator led
3
fl ashes 3 times for confi rmation. If the cooker
hood is not reset, it will automatically reset
after the motor of the cooker hood has been
switched on 10 times.
Installing the monoblock fi lter
Refer to your recirculation kit manual for removal and
installation of the monoblock fi lter.

You can obtain a new monobloc fi lter from
a dealer or the Novy website.

3.5 Led lighting

Replacing the led lighting
First, remove the power supply from the hood and allow
the lighting to cool down suffi ciently.
1. Carefully press the spotlight holder; next, remove the
spotlight holder by means of a tilting movement.
2. Removing the LED spotlight:
A. First disconnect the cable leading to the LED spotlight
to be replaced. Disconnecting is done by releasing the
lock by applying a light pressure and pulling it off at
the same time.
B. Then remove the LED spotlight to be replaced by making
a soft rotating movement counterclockwise.
C. Remove the LED spotlight to be replaced from the
bayonet ring.
– 39 –
2