Checking/Reloading Battery Of Receiver Collar; Changing The Contact Points; How To Check That Your Canicom 800 Expert/Canicom 1200 Expert Is Functioning Properly - Num'axes CANICOM 800 Expert Guide D'utilisation

Checking/reloading battery of receiver collar


To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
− battery sufficiently charged: flashes slowly green
− weak battery: flashes quickly green
When the battery is too weak, the product switches to safety mode and the system locks up.
Recharge the battery by following the procedure indicated above, at the beginning of this user's guide
(See § Charge of the CANICOM Expert collar).

Changing the contact points


Two different series of contact points are supplied. The length of the contact points must be sufficient to
have proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate,
remove and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
You can purchase extra-long contact points from your supplier at any time.
How to check that your CANICOM 800 Expert/CANICOM 1200 Expert is

functioning properly
You can check that your CANICOM 800 Expert/CANICOM 1200 Expert is operating correctly at any time.
- Before doing so, make sure that the receiver collar is turned "Off" (indicator light off).
- Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening
them so as to pinch the test lamp wires under the contact points).
- Turn "On" the remote control and receiver collar you want to test.
- Select the receiver collar you want to test on the remote control:
For CANICOM 800 Expert:
Press the A or B key in order to select the collar (the letter A or B will appear on the LCD screen).
For CANICOM 1200 Expert:
Press the 1, 2, 3 or 4 key in order to select the collar (the number 1, 2, 3 or 4 will appear on the LCD
screen).
- Press the F or C button and modify the level of intensity of the stimulations: the test lamp will come on
with more or less intensity.
Renew the same procedure for each receiver collar you want to test.
Gb - 29