Checking/Replacing Battery Of Receiver Collar; Fitting The Receiver Collar - Num'axes CANICOM VOICE 200 Guide D'utilisation

Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be prepared to replace
battery.
Replace the old battery with a new one as follows:
−
On the back of the remote control, unscrew the screw and remove the battery cover.
−
Remove the old battery.
−
Insert the new battery (3-V CR2430 lithium) making sure the polarity "+" noted on the battery is visible
(Diagram 6).
−
Put the battery cover back in place and retighten the screw.
−
Check the remote control operates properly.
The "+" symbol on the
battery must be
visible.
•

Checking/replacing battery of receiver collar

To check the condition of the battery, observe the indicator light located on the front of the receiver collar when
you switch it on or when you press a button of the remote control:
−
Flashes slowly green: battery sufficiently charged.
−
Flashes quickly red: weak battery. Be prepared to replace battery.
Replace the old battery with a new one (see § First use from new: Fitting the battery in the receiver collar) then
check the collar operates correctly.
•

Fitting the receiver collar

Collar adjustment is very important:
−
If the strap is too loose, the collar is likely to move and the loudspeaker won't be on the top of the neck.
−
If the strap is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
You should always direct the collar to your dog's neck as follows: the loudspeaker should be positioned on the top
of your dog's neck (Diagram. 7)
Guide d'utilisation CANICOM Voice – indice B
Diagram 6
Fitting the battery in the
remote control
WARNING
When inserting the battery,
make sure the polarity is correct.
19/56