Fitting The Strap On The Collar - Num'axes CANICOM VOICE 200 Guide D'utilisation

•
Activate/deactivate the remote control
Remote control is supplied with battery fitted. No manual handling is required.
To increase the battery life, we recommend you to remove the battery from the remote control if you are not
using it for a long period.
•
Activate/deactivate the receiver collar
You can activate/deactivate the receiver collar with the magnetic key or with the remote control.
Activate/deactivate the collar with the magnetic key or the remote control
−
Activate: move the magnetic key or the grey rectangle of your remote control towards the collar so that it
comes into contact with the
flash in green indicating the collar is On.
−
Deactivate: move the magnetic key or the grey rectangle of your remote control towards the collar so that
it comes into contact with the
flashes from green to red then goes out indicating the collar is Off.
To increase the battery life, we recommend you to deactivate the collar if you are not using it for a long period.
Diagram 4
Activate/deactivate the receiver collar with
the magnetic key or the remote control
•

Fitting the strap on the collar

To fit the strap on the collar, glide the strap (side without buckle) alongside the case, pass the strap that does not
have a loop in the first pass of the collar. Continue and slide the strap under the collar then into the second pass
and finally into the strap guide and loudspeaker.
Guide d'utilisation CANICOM Voice – indice B
symbol, hold for 1 second (Diagram 4). The indicator light on the collar will
symbol, hold for 1 second (Diagram 4). The indicator light on the collar
Approach until coming in contact
these two areas during 1 second
16/56