Fitting The Strap; Switching On The Collar; Switching Off The Collar; Changing Operating Modes - Num'axes iki voice Guide D'utilisation

Fitting the strap

- Glide the strap alongside the case (See diagram 4).
- Place the slide buckle supplied on the strap.
- Attach the quick-snap buckle to the free edge of the strap.

Switching On the collar

Briefly place (for less than 1 second) the magnetic key close to the orange mark placed in front of the
collar. 1, 2 or 3 short sound beeps are emitted (according to the chosen mode) and indicate(s) that the
collar has been switched on.
In the factory, the collar's mode is positioned on mode 2 (beep sounds then vocal messages).

Switching Off the collar

Briefly place (for less than 1 second) the magnetic key close to the orange mark placed in front of the
collar.
One long sound beep indicates that the collar has been switched off.

Changing operating modes

In the factory, the collar's mode is positioned on mode 2 (beep sounds then vocal messages).
To change the collar's mode, when switching on the collar you need to approach and keep the magnetic
key in contact with the orange mark.
A series of sound beeps is emitted (from 1 to 3 beeps) indicating the selected mode.
Keep the magnetic key in contact with the orange mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously
selected.
Diagram 4
Gb - 15