Checking/Replacing Battery Of Remote Control; Checking/Replacing Battery Of Receiver Collar - Num'axes EYENIMAL Training Pulse Guide D'utilisation

C hecking/replacing battery of EYENIMAL Training Pulse remote control

To check the condition of the battery, observe the indicator lights located on the remote control.
If the 5 indicator lights flash quickly 3 times when you press a button, the battery is weak.
Be prepared to replace it.
Performance (radio range) of the remote control may deteriorate as battery becomes weak.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be compatible with your
product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Replace the old battery with a new one as follows:
- On the back of the remote control, use a coin to remove
the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2032)
making sure the "+" noted on the battery is visible .
- Put the battery cover back in place and use a coin to close it.
- Check the remote control operates correctly.
Diagram 5
Replacing battery of
remote control

Checking/Replacing battery of receiver collar


To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
- battery sufficiently charged: flashes slow green.
- weak battery: flashes quickly red.
Replace the old battery with a new one (3-V Lithium CR2) (See § First use from new – Fitting the battery
in receiver collar) then check the receiver collar operates correctly.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Gb - 23
WARNING
Make sure the polarity is correct
"+" of the battery must be visible