Checking/Replacing Battery Of The Remote Control; Checking/Replacing Battery Of Receiver Collar - Num'axes Canicom Spray Guide D'utilisation

With the vibrations you can:
− send a warning to your dog when he is disobedient,
− draw his attention...
It's very important to always use the vibrations in the same way in order not to
disturb your dog.
• button: short spray
If you press the "short spray" button, the receiver collar will emit a short spray.
• button: long spray
If you press the "long spray" button, the receiver collar will emit a long spray.

Checking/replacing battery of the remote control

●
To check the condition of the battery, activate the remote control and look at the battery level
indicator on the LCD screen.
Performance (radio range) of the remote control may deteriorate as battery becomes weak. Be
prepared to replace battery.
Replace the old battery with a new one as follows:
− On the back of the remote control, unscrew the screw and remove the battery cover.
− Remove the old battery.
− Insert the new battery (3-V CR2430 lithium) making sure the polarity "+" noted on the battery
is visible (Diagram 9).
− Put the battery cover back in place and retighten the screw.
− Check the remote control operates properly.
Fitting the battery in the remote control
WARNING
When inserting the
battery, make sure the
polarity is correct.

Checking/replacing battery of receiver collar

●
To check the condition of the battery, observe the indicator light located on the front of the
receiver collar:
− Flashes slowly green: battery sufficiently charged.
− Flashes quickly red: weak battery. Be prepared to replace battery.
Replace the old battery with a new one (see § First use from new: Fitting the battery in the
receiver collar) then check the collar operates correctly.
Gb - 24
Diagram 9
The "+" symbol on
the battery must be
visible.