Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
the charge time lamp flashes red, and the battery
cannot be charged immediately. Leave the battery
inserted in the charger, and charging will
commence when the battery cools down.
● If the lamp goes out while charging, disconnect
the power cord, and leave for 3 to 5 minutes before
reconnecting. If the problem persists, call for
repairs.
● Leave 5 minutes between charging batteries as
the charger may overheat leading to malfunction.
● The battery life is finished if it can only be used
for short periods even when fully charged.
Purchase a new battery. Continuing to use a
depleted battery may cause the charger to
malfunction.
BEFORE USE
Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Installing the bit
Always follow the following procedure to install
driver bit. (Fig. 5)
Driver bit
Hexagonal hole
in the anvil
(1) Pull the guide sleeve forward.
(2) Insert the bit into the hexagonal hole in the anvil.
(3) Release the guide sleeve and it returns to its original
position.
CAUTION:
If the guide sleeve does not return to its original
position, then the bit is not installed properly.
2. Removing the bit
Please do the opposite point on the method of
installing bit.
3. Confirm that the battery is mounted correctly
4. Check the rotational direction.
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the selector button.
The L-side of the selector button is pushed to turn
the bit counterclockwise (See Fig. 6).
R
(The L and
marks are provided on the body.)
Movement
Guide sleeve
Fig. 5
R marks
5. Switch operation (Fig. 7)
CAUTION:
● Before using, confirm that the switch lever returns
to its original position when pulled and then
released. Failure of the switch lever to operate
properly can result in injury.
● Do not hang the angle impact driver from a belt
and the like by the switch lever. The angle impact
driver may drop causing an accident. In addition,
this can also damage the switch lever.
● When carrying the angle impact driver, confirm
that the lock button is in the OFF position.
Carrying the angle impact driver with the lock
switch in the ON position can cause the switch to
inadvertently be turned on resulting in injury.
● Do not carry the angle impact driver by the switch
lever when carrying. This can cause a malfunction.
● Be careful not to pinch your finger between the
switch lever and the angle impact driver. This can
cause an injury.
The switch is turned on when the switch lever is
pulled after having slid the lock button to the ON
position, and is turned off when the switch lever is
released.
The rotational speed can be controlled by varying the
amount that the switch lever is pulled. Speed is low
when the switch lever is pulled slightly and increases
as the switch lever is pulled more.
When releasing the lever of the switch, the brake
will be applied for immediate stopping.
Always make sure to return the lock button to the
OFF position after using.
Switch lever
English
Selector
button
L
marks
Fig. 6
Lock button
OFF side
ON side
Fig. 7
13
Publicité
Table des Matières
