Hitachi WH 14DCAL Instructions De Sécurité Et Mode D'emploi page 12

Masquer les pouces Voir aussi pour WH 14DCAL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Before
Charge
charging
status
lamp (RED)
While
charging
Charging
complete
Charging
impossible
Overheat
Overheat
standby
lamp
(GREEN)
NOTE:
When standby for cooling battery, UC18YRL
cools the overheated battery by cooling fan.
Regarding the temperature of the rechargeable
battery.
The temperatures for rechargeable batteries are as
shown in the table below, and batteries that have
become hot should be cooled for a while before
being recharged.
Rechargeable
batteries
BCL1430
Regarding recharging time
Table 4 shows the recharging time required
according to the type of battery.
Table 4 Recharging time (approx. min.) at 20°C
Battery
Battery capacity (Ah)
voltage (V)
14.4
BCL1430
NOTE:
The recharging time may vary according to the
ambient temperature and the power supply voltage.
4. Disconnect battery charger from the receptacle.
CAUTION:
Do not pull the plug out of the receptacle by pulling
on the cord.
Make sure to grasp the plug when removing from
receptacle to avoid damaging cord.
12
Indications of the pilot lamp
Blinks
Lights for 0.5 seconds. Does not light for 0.5
(RED)
seconds. (off for 0.5 seconds)
Lights continuously
Lights
(RED)
Blinks
Lights for 0.5 seconds. Does not light for 0.5
(RED)
seconds. (off for 0.5 seconds)
Flickers
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
(RED)
Lights
Lights continuously
(GREEN)
Table 3
Temperatures at which the
battery can be recharged
32°F — 122°F (0°C — 50°C)
3.0 Ah
45 min.
Table 2
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull out
the battery from the battery charger.
How to make the batteries perform longer.
Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery.
If you continue to use the tool and exhaust the
electric current, the battery may be damaged and
its life will become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the
battery and recharge it after it has cooled for a while.
CAUTION:
● Repair is required if the receptacle is not secured
properly or the power cord does not stay in the
receptacle. Consult your electrician. Using the
charger in this condition may lead to fire.
● If the charge status lamp is blinking orange rapidly
(in 0.2 second intervals) and the buzzer sounds
intermittently for 5 seconds, check that the hole
for connecting the battery is not obstructed.
Remove any obstructions. If no obstructions are
found, the battery or charger may be
malfunctioned. Return both to your place of
purchase.
● If the charge time lamp does not light when the
power cord is connected to the receptacle,
disconnect the power cord, and check that the
battery is attached correctly.
● The battery retains heat when used or left for
prolonged periods in direct sunlight. In this state,
Malfunction in the
battery or the charger
Battery
overheated.
Unable
to
charge
(Charging will commence
when battery cools).

Publicité

Table des Matières
loading

Table des Matières