Dometic DC-Kit4 Instructions De Montage Et De Service page 15

DC-Kit4
I
NOTE
B2600, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200: The remote
control for the roof air conditioner can only be used if the air condition-
ing is supplied with 230 Vw mains network or with the inverter.
Stationary mode: 230 Vw mains
The system is powered automatically via the inverter's integrated priority circuit from
the 230 Vw mains.
Driving mode: Power supply from the 12 V battery
➤ Switch on the inverter using the MCR9 remote control.
A
NOTICE!
B3200, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200: The inverter
may be damaged.
Do not switch on the roof air conditioner in the automatic or heating
modes.
➤ Use the roof air conditioner as described in the operating manual.
Driving mode: power supply from the 12 V battery with motor
switched off
• B2600, FJ1100, FJ1700, FJ2200, FJ2600, FJ3200
If the inverter switches off due to low voltage in the supply battery (10.5 V), no
voltage will be supplied to the socket and the roof air conditioner switches off.
The inverter is in standby mode.
As soon as the power from the supply battery reaches the inverter's activation
point, the socket is supplied with voltage again.
You have to switch on the roof air conditioner again manually, as the control
electronics need to be reactivated after a lack of voltage.
• B3200
If the inverter switches off due to low voltage in the supply battery (10.5 V), no
voltage will be supplied to the socket and the roof air conditioner switches off.
The inverter is in standby mode.
As soon as the power from the supply battery reaches the inverter's activation
point, the socket is supplied with voltage again.
The roof air conditioner starts automatically.
EN
Using the DC Kit
15