Instructions For Accessing And Changing Parameters In Maxi-Smart Menus - Cattani Maxi-Smart Manuel D'utilisation

• Instructions for accessing and changing
parameters in the Maxi-Smart menus
Main menus
When switched on the graphic display will show the Cattani
logo for 10 seconds, then the main menu will appear.
Main menu "A1"
This shows some parameters such as vacuum level, time
for aspirator activation, temperature, amalgam container (if
present) and system software revision.
Control menu "A2"
This shows: number of times the Maxi-Smart was switched
on, total hours switched on, number of activations of the
aspirator, actual hours of use of the aspirator, the average
hours the blower alone was on and the number of fan ac-
tivations.
Event menu "A3"
This shows the last 10 events or alarms indicated by a
number, to decode the event see table on page 54.
Control menu "A2"
COUNTERS – ODOM . A2
POWER CYCLES
UPTIME [ h]
WORK CYCLES
WORK TIME [ h]
ASPIRATOR [ h]
FAN CYCLES
000000 Number of switch-on from master switch
000000 Total hours system on
000000 Number of activations by aspiration control
000000 Actual hours of operation (motors on)
000000 Average operation hours of aspiration motor (Medio-
Jet 2V)
000000 Number of control panel cooling fan activation.
41