Instructions To Navigate Turbo-Smart Menus And To Modify Some Parameters; Main Menus - Cattani TURBO-SMART Manuel D'utilisation

Instructions to navigate Turbo-Smart menus
and to modify some parameters

Main menus

When Turbo-Smart is switched on, the display shows the
Cattani logo for 10 seconds, after which time the main menu
appears.
Main Menu "A1"
This menu shows some parameters such as: cycles, suc-
tion activation time, temperature, presence/absence of the
amalgam container and system software release.
Control Menu "A2"
The display shows the number of times Turbo-Smart has been
switched on by means of the main switch (Power Cycles), the
total hours Turbo-Smart has had power supplied (Uptime), the
number of times suction has been activated (Work Cycles), the
total running hours of the aspirator (Work Time), the average
working hours of the blower (Aspirator) and the number of times
the control panel cooling fan has been activated (Fan Cycles).
Events Menu "A3"
The menu shows the last 10 events or alarms that have oc-
curred to Turbo-Smart.
Alarms are indicated with a number; refer to the table to
identify them.
Control Menu "A2"
COUNTERS – ODOM . A2
POWER CYCLES
UPTIME [h]
WORK CYCLES
WORK TIME [h]
ASPIRATOR [h]
FAN CYCLES
HOME
Number of times the aspirator has been switched on by means of the
000000
main switch.
000000 Total hours Turbo-Smart has had power supplied.
000000 Number of times the aspirator has been activated by the dental unit.
000000 Number of real running hours (motors running).
000000 Average working hours of the aspiration motor (UNI-JET 75).
000000 Number of times the control panel cooling fan has been activated.
28
INDEX