Setting Up On Uneven Surfaces; Freezing Parts - Titan PowrCoat 630 Mode D'emploi

Safety precautions
1.3

Setting up on uneven surfaces

The front side of the unit must point downwards to prevent sliding
away.
GB
1.4

Freezing Parts

The temperature of some components of the unit can drop below 32º
F (0º C) during usage, and may show a build-up of frost. Refer to the
diagram below for the area of the pump most likely to reach freezing
temperatures. Avoid touching any components in this area during
usage.
Operating Temperature
This equipment will operate correctly in its intended ambient, at a
minimum between +50ºF (+10°C) and +104ºF (+40°C).
Relative Humidity
The equipment will operate correctly within an environment
at 50% RH, +104ºF (+40°C). Higher RH may be allowed at lower
temperatures.
Measures shall be taken by the Purchaser to avoid the harmful effects
of occasional condensation.
Altitude
This equipment will operate correctly up to 2100 m above mean sea
level.
Transportation and Storage
This equipment will withstand, or has been protected against,
transportation and storage temperatures of -13ºF (-25°C) to 131ºF
(+55°C) and for short periods up to 158ºF (+70°C).
It has been packaged to prevent damage from the effects of normal
humidity, vibration and shock.
4 PowrCoat