Titan PowrCoat 630 Mode D'emploi page 10

Operation
5. Fill the oil cup 1/2 full with Piston Lube (P/N 314-480). This
extends packing life.
Piston Lube prevents increased wear and tear to the
packings.
Attention
6. Verify that the air compressor meets the power requirements
necessary to effectively power the sprayer. See "Technical
Data", section 3.4 to determine air requirements.
7. Prior to connecting the compressor to the unit, perform the
following in order to prevent accidental startup:
a. Close the shutoff valve (fig 7, item 1). The figure shows the
handle in the closed position.
b. Turn the air regulator (2) fully counterclockwise to its lowest
pressure setting.
c. Open the bleed valve (3) by turning it fully counterclockwise.
The bleed valve handle should be pointing down.
8. Remove the red plug from the air hose fitting (Fig. 8, item 1).
Attach the air hose and tighten wrench tight. All units are
equipped with a 3/8" NPT (M) nipple.
Proper earthing (grounding) is important. The
passage of some materials through the nylon fluid
hose will build up a static electric charge, which if
discharged, could ignite solvent vapors present and
create an explosion.
1
2
3
1
GB
9. Make sure the sprayer is earthed (grounded). All sprayers are
equipped with a earthing (grounding) cable (1). Clip the end
of the grounding cable to a true earth ground.
10. Strain all paints with a nylon strainer to ensure trouble free
operation and freedom from frequent cleaning of the inlet
screen and gun filter.
11. Make sure the spray area is well ventilated to prevent
hazardous operation with volatile solvents or exhaust fumes.
If lacquer or other flammable materials are to be
sprayed, ALWAyS locate the compressor outside the
immediate spraying area. Failure to do so may cause
an explosion.
12. Locate the compressor outside the immediate spraying area
to avoid clogged air intake of the compressor with overspray.
8
1
PowrCoat