Hints And Tips - ZANKER KDI10001XB Notice D'utilisation

If you stop to use the combi detergent tablets,
before you start to use separately detergent, rinse
aid and dishwasher salt, do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the rinse aid
dispenser are full.
3. Start the shortest programme with a rinsing
phase, without detergent and without dishes.
4. Adjust the water softener to the water hardness in
your area.
5. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to start a
programme.
Turn the programme knob until the programme marker
is aligned with a programme on the control panel. If
the on/off indicator comes on and the start indicator
starts to flash the appliance is in setting mode.
If the control panel does not show this condition, press
and hold the start button until the appliance is in set-
ting mode
Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker is
aligned with the symbol of the programme you
want to set.
• The on/off indicator comes on.
• The start indicator starts to flash.
4. Press the start button to start the programme.

Hints and tips

The water softener
Hard water contains a high quantity of minerals that
can cause damage to the appliance and bad washing
results. The water softener neutralises these minerals.
The dishwasher salt keeps the water softener clean
and in good conditions. It is important to set the right
level of the water softener. This makes sure that the
water softener uses the correct quantity of dishwasher
salt and water.
18
• The on/off indicator and the start indicator are
on.
• The washing phase indicator comes on.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you
close the door, the appliance continues from the point
of interruption.
Cancelling the programme
1. Press and hold the start button until the start indi-
cator starts to flash.
Make sure that there is detergent in the deter-
gent dispenser before you start a new pro-
gramme.
At the end of the programme
When the programme is completed
you do not deactivate the appliance within 5 minutes
all indicators goes off. This helps to decrease energy
consumption.
1. To deactivate the appliance, turn the knob until
the programme marker is aligned with the on/off
indicator.
2. Close the water tap.
Important
• Let the dishes become cold before you remove
them from the appliance. Hot dishes can be easily
damaged.
• First remove the items from the lower basket, then
from the upper basket.
• There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
Using salt, rinse aid and detergent
• Only use salt, rinse aid and detergent for dishwash-
er. Other products can cause damage to the appli-
ance.
• The rinse aid helps, during the last rinsing phase, to
dry the dishes without streaks and stains.
• Combi detergent tablets contain detergent, rinse aid
and other added agents. Be sure that these tablets
are applicable to the water hardness in your area.
comes on. If