Hints And Tips - ZANKER KDT10012FK Notice D'utilisation

If the control panel shows other conditions, press and
hold the programme button until the appliance is in set-
ting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appliance.
Make sure that the appliance is in setting mode.
3. Press continuously the programme button until the
indicator of the programme you want to set comes
on.
4. Close the appliance door. The programme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button to delay the start of the pro-
gramme of 3 hours. The delay indicator comes on.
3. Close the appliance door. The countdown starts.
• When the countdown is completed, the pro-
gramme starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you
close the door, the appliance continues from the point
of interruption.
Cancelling the delay start while the countdown
operates
1. Open the appliance door.

Hints and tips

The water softener
Hard water contains a high quantity of minerals that can
cause damage to the appliance and bad washing re-
sults. The water softener neutralises these minerals.
The dishwasher salt keeps the water softener clean
and in good conditions. It is important to set the right
level of the water softener. This makes sure that the
water softener uses the correct quantity of dishwasher
salt and water.
Using salt, rinse aid and detergent
• Only use salt, rinse aid and detergent for dishwash-
er. Other products can cause damage to the appli-
ance.
• The rinse aid helps, during the last rinsing phase, to
dry the dishes without streaks and stains.
2. Press the delay button, the delay indicator goes off.
3. Close the appliance door. The programme starts.
Cancelling the programme
1. Open the appliance door.
2. Press and hold the programme button until the indi-
cator of the set programme goes off and the end
indicator flashes.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
At the end of the programme
When the programme is completed, an intermittent
acoustic signal operates and the end indicator comes
on.
1. Press the on/off button to deactivate the appliance.
2. Close the water tap.
Important
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily dam-
aged.
• First remove the items from the lower basket, then
from the upper basket.
• There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
• Combi detergent tablets contain detergent, rinse aid
and other added agents. Be sure that these tablets
are applicable to the water hardness in your area.
Refer to the instructions on the packaging of the
products.
• Detergent tablets do not fully dissolve with short pro-
grammes. To prevent detergent residues on the ta-
bleware, we recommend that you use the tablets
with long programmes.
Do not use more than the correct quantity of de-
tergent. Refer to the instructions on the detergent
packaging.
Loading the baskets
Refer to the supplied leaflet with examples of the
load of the baskets.
21