Hitachi B16RM Mode D'emploi page 15

Fig. H
INSTALLING LIGHT BULB (FIG. I) (not included)
1. Install a light bulb (no larger than 60 watt) into the
socket inside the head.
Fig. I
WARNING
1. To prevent injury resulted from heat of the light bulb
(1). Never touch the light bulb (1).
2. To prevent electric shock. Never touch the bulb
socket (2) when the plug from the power source is
connected.
INSTALLING THE CHUCK GUARD ASSEMBLY
(FIG. J)-FOR FRANCE, HUNGARY AND POLAND
ONLY
1. Put the nut (5) into the chuck guard hole (6).
2. Make the bolt (8) go through hole (7), bracket (10)
and hole (6) and then tighten.
3. Secure the bracket (10) with the two screw (11) onto
the laser assembly (13) and then tighten.
4. Tighten the lock knob (12) into the bracket (11) to
adjust position of the chuck guard.
Fig. J
3
2
1
4
1
13
6
7
11
10
9
12
8
DRILL PRESS ADJUSTMENTS
CAUTION: All the adjustments for the operation of the
drill press have been completed at the factory. Due to
normal wear and use, some occasional readjustments
may be necessary.
To prevent personal injury, always disconnect the plug
from the power source when making any adjustment.
BEVEL SCALE (FIG. K)
NOTE: The bevel scale has been included to measure
approximate bevel angles. If precision is necessary, a
square or other measuring tool should be used to
position the table. To use the bevel scale (6):
1. TIGHTEN the nut (4) on the locking pin in the
clockwise direction to RELEASE the pin from the
table support.
2. Loosen the large hex head bevel locking bolt (5).
To prevent injury, be sure to hold the table & table arm
assembly, so it will not swivel or tilt.
3. Tilt the table, aligning the desired angle measurement
to the zero line scribed on the table opposite the
bevel scale (6).
4. Tighten the bevel locking bolt (5).
5. To return the table to its original position, loosen the
bevel locking bolt (5). Realign the bevel scale (6) to
the 0° scribed line on the table.
6. Loosen by turning counterclockwise the nut (4) on
the locking pin to the end of the threads. Tap the pin
into its original position.
7. Tighten the bevel locking bolt.
NOTE: The table has been removed from the illustration
for clarity.
To prevent personal injury, always disconnect the plug
from the power source when making any adjustment.
Fig. K
5
– 15 –
WARNING
WARNING
WARNING
6
5
4
English