Thermal Insulation Of The Product; Handing The Product Over To The End User; Procuring Spare Parts; Draining The Product - Vaillant VPS R 100 1 M Notice D'installation Et De Maintenance

6.2

Thermal insulation of the product

The product comes with thermal-insulation casing.
Significant heat is exchanged at the water connections and
the plugs if these are not thermally insulated.
In heating mode, this heat exchange leads to a reduction in
the heating output and to the temperature level falling.
Note
In cooling mode, this heat exchange leads to a
reduction in the system output and to the temper-
ature level rising which, in turn, leads to increased
condensation.
▶
Apply thermal insulation to the water connections, the
outlet plug on the cylinder and all other pipes in order to
limit the heat exchange and therefore reduce the risk of
condensation.
7 Handing the product over to the end
user
▶
Once the installation is complete, answer any questions
that the end user may have.
8

Procuring spare parts

The original components of the product were also certified
by the manufacturer as part of the declaration of conformity.
If you use other, non-certified or unauthorised parts during
maintenance or repair work, this may void the conformity of
the product and it will therefore no longer comply with the
applicable standards.
We strongly recommend that you use original spare parts
from the manufacturer as this guarantees fault-free and safe
operation of the product. To receive information about the
available original spare parts, contact the contact address
provided on the reverse of these instructions.
▶
If you require spare parts for maintenance or repair
work, use only the spare parts that are permitted for the
product.
9

Draining the product

Applicability: VPS R 100/1 M
▶
Drain the product via the lowest hydraulic connection
on the cylinder.
Applicability: VPS R 200/1 B
▶
Unscrew the plug (1) to drain the product.
0020244064_01 Installation and maintenance instructions

Handing the product over to the end user 7

10 Permanently decommissioning

1. Drain the product.
2. Remove the product.
3. Either recycle the product along with its components, or
scrap it completely.

11 Recycling and disposal

▶
The competent person who installed your product is re-
sponsible for the disposal of the packaging.
If the product is labelled with this mark:
▶
In this case, do not dispose of the product with the
household waste.
▶
Instead, hand in the product to a collection centre for
waste electrical or electronic equipment.
If the product contains batteries that are labelled with
this mark, these batteries may contain substances that are
hazardous to human health and the environment.
▶
In this case, dispose of the batteries at a collection point
for batteries.

12 Customer service

The contact details for our customer service are provided on
the back page or on our website.
1
75