Tecno-gaz Europa B EVO Mode D'emploi page 45

13. PROGRAMMING AND PARAMETERS DISPLAY
13.1 LANGUAGE SELECTION
13.2 HOURS SELECTION
13.3 MINUTES SELECTION
13.4 SECONDS SELECTION
13.5 DATE SELECTION
13.6 MONTH SELECTION
13.7 YEAR SELECTION
13.8 VISUALIZE ATMOSPHERIC PRESSURE
13.9 WATER LOADING SELECTION
14. SOLUTION TO OPERATION PROBLEMS
14.1 AUTOCLAVE DOES NOT DRY CORRECTLY
14.2 AUTOCLAVE CHAMBER BECOMES WHITE
14.3 AUTOCLAVE CHAMBER PRESENTS GREEN STAINS
14.4 INTERRUPTION OF THE STERILIZATION CYCLE
14.5 AUTOCLAVE DOES NOT RECEIVE COMMANDS
14.6 AUTOCLAVE PRINTER DOES NOT PRINT
14.7 STAINS ON INSTRUMENTS
15. DEMINERALIZER
15.1 SET OF DEMINERALIZER SYSTEM
15.2 CONNECTION AND PLUG OF DEMINERALIZER SYSTEM
15.3 CHANGE RESINS OF FILTER
16. STANDARD STERILIZATION PROCEDURE
17. PROCEDURES FOR SERVICE AND ASSISTANCE
A. MAINTENANCE
THE MANUFACTURER RESERVES THE RIGHT TO CARRY OUT IMPROVING TECHNICAL
CHANGES WITHOUT ANY PREVIOUS NOTICE. THIS MANUAL IS A SOLE PROPERTY OF
TECNO-GAZ S.P.A. AND CANNOT BE COPIED, REPRODUCED OR TRANSFERRED TO THIRD
PARTIES WITHOUT THE WRITTEN AUTHORISATION OF TECNO-GAZ S.P.A.
ENGLISH
3