Velleman DVR16M Mode D'emploi page 6

c) Back Panel Description
1. LOOP connectors: bring the channel input signal out again to connect to an additional VCR, monitor etc.
2. VIDEO IN: to connect a video source such as a camera.
3. 75/HI switches: set these switches to the right position for the destination device when using the loop function.
4. POWER: connect the provided adapter to this connector and plug it into the mains.
5. External I/O: the device can be controlled remotely by an external device or trigger mechanism (see diagrams
below for connections).
6. CALL: to connect a call monitor.
7. MONITOR: to connect the main monitor.
8. AUDIO IN: to connect an audio source such as a microphone (only when IPS is 15A for NTSC or 12A for PAL).
9. AUDIO OUT: to connect to a monitor or speaker system (only when IPS is 15A for NTSC or 12A for PAL).
25-pin COM port 9-pin COM port
DVR16M
- 6 - VELLEMAN