Velleman DVR16M Mode D'emploi page 4

3. Configuration
a) Installing HDD
1) HDD Description
1. Handle of the HDD tray
2. Tray lock:
In position A (cf. drawing on the right), the tray is locked and cannot be removed.
In position B, the tray is unlocked and can be removed.
The key lock must be in position A before you switch on the device,
if not the hard disk drive cannot be used in a regular way.
3. Power indicator (green LED): lights up when the device is switched on.
4. HDD access indicator (yellow LED).
2) Installing the Hard Drive into the Tray
• Open the plastic HDD compartment door.
• Unlock the tray lock of the desired tray, pull out the handle and pull the tray out of the device.
• Push the release latch at the left ("OPEN") to slide the top cover backwards and remove it.
• Connect the DC power cable and IDE cable to the HDD.
• Insert the HDD in the tray and secure the HDD through the screw holes in the sides.
• Put the top cover back on the tray and slide it forward to secure it.
• Slide the tray back into the device and lock the tray lock.
• Close the plastic HDD compartment door.
! When using 2 HDDs at the same time, make sure to set one as 'master' and the other as 'slave' by means of the
jumper on the HDDs themselves.
! This device does not support hot swap. Power down the unit and leave it off for more than 60 seconds before
opening it to replace a HDD.
3) Max. Recording Time
The recording time depends on the recording speed and quality. Please refer to the tables below:
Note: these data are the results of a test during which regular TV programs were recorded
NTSC SYSTEM
IPS
rec. Best
quality
High
Normal
Basic
HDD type
DVR16M
25A 15
48hr 96hr
60hr 120hr
96hr 192hr
160hr 320hr
8 4
180hr 360hr
226hr 450hr
360hr 720hr
600hr 1200hr
240GB
- 4 -
2 1
720hr 1440hr
900hr 1800hr
1440hr 2880hr
2400hr 4800hr
VELLEMAN