Velleman DVR16M Mode D'emploi page 10

10) TIME Set-Up
1. Press or to choose the date and time indication and the ENTER button to open the menu.
2. Press or to change the value and
3. Press MENU to confirm the current set-up and return to the previous menu.
4. Press MENU again to exit and close the system set-up menu.
11) Change Password (default password : 0000)
1. Press or to choose 'New password' and the ENTER button to open the password menu.
2. Press or to change the value and
3. Press MENU to confirm the current set-up and return to the previous menu.
4. Press MENU again to exit and close the system set-up menu.
12) CLEAR HDD Yes / No Set-Up
1. Press or to choose CLEAR HDD and the ENTER button.
2. Press or to set CLEAR HDD: MASTER or SLAVE.
3. Press ►or ◄ to choose between Yes and No:
Yes: press ►to clear the HDD . No: press◄ NOT to clear the HDD.
4. Press MENU to confirm the current set-up and return to the previous menu.
5. Press MENU again to exit and close the system set-up menu.
13) SYSTEM RESET Set-Up
1. Press or to choose SYSTEM RESET and the ENTER button.
2. Press or to choose SYSTEM RESET: YES/NO.
Yes: to reset the system (Time & Password set-up will not be changed).
No: not to reset the system.
3. Press MENU to confirm the current set-up and return to the previous menu.
4. Press MENU again to exit and close the system set-up menu.
14) REMOTE MODE Set-Up
1. Press or to choose REMOTE MODE and the ENTER button to open the menu.
2. Press or to set REMOTE MODE: RS-232 / RS-485.
3. Press MENU to confirm the current set-up and return to the previous menu.
4. Press MENU again to exit and close the system set-up menu.
15) Remote Protocol Transmission BAUD RATE Set-Up
1. Press or to choose BAUD RATE and the ENTER button to open the menu.
2. Press or to set BAUD RATE: 115200 / 57600 / 19200 / 9600 / 4800 / 3600 / 2400 / 1200.
3. Press MENU to confirm the current set-up and return to the previous menu.
4. Press MENU again to exit and close the system set-up menu.
16) REMOTE ID Set-Up (only when RS-232 is selected as remote protocol)
The RS232 protocol allows you to operate several DVR16M. The identification number can vary from 000 to 255.
1. Press or to choose REMOTE ID and the ENTER button to open the menu.
2. Press or to set REMOTE ID: 000~255.
3. Press MENU to confirm the current set-up and return to the previous menu.
4. Press MENU again to exit and close the system set-up menu.
DVR16M
or to move to the previous or next value.
or to move to the previous or next value.
- 10 -
All Data in HDD
Will Be Cleared
Are you sure?
(◄: No ►: Yes)
VELLEMAN