Initial Operation; Remote Control; Power Supply; Switch Sensowash ® On - DURAVIT SensoWash Slim 611000 Notice D'utilisation

5. Initial operation

Remote control

> Press the lock of the "Battery Compartment"
> Remove the foil safety tag in the battery compartment.
> Close the "Battery Compartment"

Power supply

> Connect the main power supply.
SensoWash
®
when it is connected to the power supply. During this time, the
"Status LED"
unit can work, all other operations will not work.
Switch SensoWash
Requirement: SensoWash
LED" is red illuminated.
B
> Press "Power"
SensoWash is now switched on.
®
The "Status LED"
All functions can be used.

6. Operating

6.1 Switching the SensoWash
> Press "Power"
A green Status LED indicates "On mode".
> Press "Power"
A red Status LED indicates "Standby mode".
will start "Initialization" for about 15 seconds
flashes green and only "Power"
B
on
®
is in the "Standby mode", the "Status
®
on the seat unit.
A
is green illuminated.
B
on the seat unit to switch on SensoWash
A
on the seat unit again to switch off SensoWash
A
8
.
8
on / off
®
to open it.
on the seat
A
.
®
®
EN
.
11