DURAVIT SensoWash Slim 611000 Notice D'utilisation page 8

Only use the device when it is fully functional
• Make sure that the power cord is not damaged.
• The power cord must not become jammed or pinched.
• Keep the power cord away from hot surfaces and sharp edges.
• Do NOT use the product if it is not working properly.
Disconnect from the power supply immediately. Close the stop
valve to interrupt the water supply. Contact help@duravit.com.
EN
Avoid malfunctions and damage to the product as a result of
improper use.
CAUTION
• Supply the device with cold drinking water from the main water
system.
• The product itself does not have electrical leakage protection
function, it must be installed in circuit where there is leakage
protection device installed.
• Means for disconnection must be incorporated in the fixed wir-
ing in accordance with the wiring rules and having a contact
separation in all poles that provide full disconnection under
overvoltage category III conditions.
• Check the rated power and choose cable cross section accord-
ingly.
• Do NOT sit, stand or lean on the lid.
• Do NOT connect any waste water, grey water, industrial water,
sea water or other untreated or semi-treated water.
• Do NOT damage the surface of the seat.
• DO NOT open and close seat and lid with excessive force.
• If the SensoWash
location, condensation may form. Leave the unit switched off
for a few hours.
• Do NOT install the SensoWash
ger of frost. The room temperature must not be less than 39 °F
(4 °C).
• Do NOT place open fire sources, candles, cigarettes, or similar,
on the SensoWash
4
Health damage and potential product damage!
is moved from a cold location to a warm
®
.
®
in rooms where there is a dan-
®